Product Code: 29244

Sika Multiseal Sealing Flashing Tape 450mm x 10m SKMULTI450

�

�

�

Product Option: 450mm x 10m SKMULTI450

Barcode: 5055492700322

Sika Multiseal Sealing Flashing Tape

�

This product has been discontinued please see alternative below:

�

�

�

�

�

�

450mm Wide Strong self adhesive flashing tape

Strong self-adhesive bituminous sealing tape for the sealing of cracks and joints in many common domestic and commercial situations. Made from aluminium foil reinforced by a polyester film and coated with a cold-adhesive bituminous compound. simply press the tape into place by hand or roller.

�

Multiseal Benefits

Replaces need for expensive lead flashing.

Self-adhesive requires no separate glue.

Very easy to apply

Very economical

Good adhesion to many substrates

Weather-proof

UV-resistant

Can be over-painted

Can be applied at low temperatures

�

Areas of Use

General repair to existing flashing.

Flashing bituminous felt and similar types of roofs.

Flashing parapet walls.

Sealing roof glazing.

Replacing lost lead flashing.

Repairs to cracks in concrete.

Repairs to lead gutters.

Sealing capping bolts in roof sheets.

Sealing roof ridges.

Flashing between timber brickwork or blockwork cavities.

Flashing of skylights

�

Notes

Prime very porous surfaces with Everbuild flashing primer.

Do not apply to damp surfaces.

In cold weather adhesion may be reduced.

Bring up to temperature or heat bitumen adhesive layer gently with a hot air gun to improve adhesion and pliability.

Awkward areas and tops of existing lead flashing can be pointed using Everbuild Lead mate or Sika lead and gutter sealant larger flat areas can be coated with Evercryl Fibre reinforced coating.

�

Preparation

Surfaces must be dry,

Sound free from oil, grease and dust

Remove all loose material by scraper or wire brush.

Porous surfaces, such as concrete or brick, should be primed using Everbuild flashing tape primer.�

�

Applying

Cut to the required length.

Peel beck approximately 5cm of release carrier and place the tape into position.

Continue removing the release carrier whilst firmly placing the tape

Avoid unnecessary creasing.

Ensure intimate contact and ensure no air is trapped.

Using a small roller ensure that all edges and overlaps are sealed properly.

Overlaps should be at least 25mm.

�

Video Demonstration of the Sika Multiseal Sealing Tape.

�