Product Code: 29984

Sika Damp Proof Slurry DPM 25kgSKDPSLUR25

�

�

�

�

�

Sika Damp Proof SlurryDPM 25kg

MPN:SKDPSLUR25

Barcode:5055047201021

ProductDescription:

Sika Damp-proofing Slurry is a ready to use(just add water),

Its a high quality, thin layer waterproofslurry coating.

Based on special cements and admixtures toprovide a water and damp proof finish.

�

When mixed with water a slurry or mortarmaterial is produced for direct application to a variety ofconstruction substrates.

�

Sika Damp-proofing Slurry is usedfor:

Waterproof coating for tanking residentialdomestic basements

Thin layer mortar or slurry coatinglining

For internal waterproofing damp-proofing ofbasement and cellar walls and floors

For interior and exterior damp proofing ofbasement walls in new buildings

For interior and exterior waterproofing ofconcrete, renders, brickwork and blockwork structures

Lining of water tanks, pools, plantersetc

�

Characteristics:

Low odour compared to traditional DPM bitumen coatings

Easy to use and apply

BBA approved

Just add water

Brush, trowel or spray applied

Easy and fast mixing

Consistency can be varied to suit applicationmethod

Good adhesion

Excellent workability

Protects against water penetration

Non toxic

�

Layer Thickness:

1mm min. 2mm max in 1 coat.

For damp-proofing use minimum 2.0mmthickness

For waterproofing use minimum 4.0mmthickness

�

Coverage:

Dependent on the substrate roughness, surfaceprofile and thickness of the layer applied.

As a guide, 2.1 kg/m2/mm (excluding allowancesfor loss wastage, surface profile and porosity, etc.).

1 unit of 25 kg yields will cover approximately6.5-7.0m2 @ 2.0mm thickness.

�

Mixing:

Slurry application by brush: 4.5 ? 4.7 Lwater per 25 kg bag

Mortar application by trowel: 4.0 ? 4.25L water per 25 kg bag

Spray application: 4.0 ? 4.5 L water per25 kg bag

�

Waiting Time andOvercoating:

Apply 2nd coat within 24 hours of firstcoat.

�

Notes:

Sika Damp-proofing Slurry does not provide atrafficable finish. Protect with a levelling screed.

�

Special attention is required to avoidpuncturing the waterproof coating with fixings. These should beaccommodated either by surface bonding with Sikaflex EBT.

�

Sika Damp Proofing Slurry will not bond tosurfaces that have been treated previously with a waterrepellent.

�

Finishing plasters may take longer to set whenapplied over the Damp-proofing Slurry.

�

Always refer to Sika Technical Datasheet before using this product

�

�

�

Related Product:

�