Product Code: 23145

Everbuild Black Jack Self Adhesive Flashing Tape 10m x 300mm

�

�

�

Everbuild Flashing Tape 10m x 300mm

Product Option: FLAS300

300mm Wide Aluminium foil and bitumen rubber self adhesive flashing tape

The adhesive forms a strong waterproof seal by the simply pressing the tape into place by hand or roller.

�

Areas Flashing Tape Can Be Use and Benefit:

Replaces need for expensive lead flashing.

Self-adhesive requires no separate glue.

General repair to existing flashing.

Flashing bituminous felt and similar types of roofs.

Flashing parapet walls.

Sealing roof glazing.

Replacing lost lead flashing.

Repairs to cracks in concrete.

Repairs to lead gutters.

Sealing capping bolts in roof sheets.

Sealing roof ridges.

Flashing between timber brickwork or blockwork cavities.

Flashing of skylights

�

Important Product Notes

Prime porous surfaces with Everbuild flashing primer.

Do not apply to damp surfaces.

In cold weather adhesion may be reduced.

Bring up to temperature or heat bitumen adhesive layer with a hot air gun to improve adhesion and pliability.

Awkward areas and tops of existing lead flashing can be pointed using Everbuild Lead mate or Sika lead and gutter sealant.

�

Preparation of Surfaces and Application:

Surfaces must be dry,

Sound free from oil, grease and dust

Remove all loose material by scraper or wire brush.

Porous surfaces, such as concrete or brick, should be primed using Everbuild flashing primer.

Cut to the required length.

Peel beck approximately 5cm of release carrier and place the tape into position.

Continue removing the release carrier whilst firmly placing the tape

Avoid unnecessary creasing.

Ensure intimate contact and ensure no air is trapped.

Using a small roller ensure that all edges and overlaps are sealed properly.

Overlaps should be at least 25mm.

�

�

Data Sheets:

300mm Flashing Tape Technical Data Sheet

300mm Flashing Tape MSDS Safety Data Sheet

�

Related Product:

�