UltraTile Level IT One - Floor Leveller - 48 No. x 25 kg Bags

Product Code: 31085

UltraTile Level IT one is a high strength, rapid curing and drying cementitious smoothing and levelling compound. It provides a strong, sound, even base which creates an ideal substrate for the fixing of tiles large or small.\n?\n\n\nPolymer modified\nProtein free\n3-50mm depth\nRapid set\nFoot traffic in 2-3 hours\nSuitable for underfloor heating\nShrinkage compensated\nPumpable\n20-30 minutes open time\n2-3 hours set time\nInternal floors\nSize: 25kg\n\n\n?\nINFORMATION\nUltra Tile Level IT one is a high strength, rapid curing and drying cementitious smoothing and levelling compound. It provides a strong, sound, even base which creates an idea substrate for the fixing of tiles large or small. The formulation incorporates specially graded fillers, cements and polymers with a rapid curing profile to enable early fixing of tiles even at thicker depth application.\nIt is mixed with clean cold water to give a free flowing product that can be applied from 3 to 50mm in one application. A high inherent strength makes it ideal for preparing subfloors prior to installation of tiling materials whilst its flow characteristics give a smoothness suitable for bonding of carpets, wood flooring, vinyl and other resilient floorings in areas ranging from residential to heavy commercial projects.\nSuitable substrates include concrete, sand/cement screeds, flooring grade plywood overboarding (minimum 15mm), cement faced tile backer boards, epoxy surface Damp Proof Membranes (DPM) and calcium sulphate screeds (call Ultra Tile for priming requirements). Level IT one is not recommended over chipboard or particleboard flooring.\nIt is suitable for use over heated screeds where the heating has been fully commissioned (for other underfloor heating systems please contact Ultra Tile for advice). All subfloors must be protected from subground moisture by the incorporation of a constructional base DPM. Check older properties, particularly pre 1970s, which may not have a base DPM and consult Ultra Tile for advice. Residual construction moisture should be controlled by the use of an Ultra Floor DPM. Plywood overboarded floors should be sealed on the underside and perimeters with Prime IT Multi-surface Primer. Plywood absorbency differs depending on the nature of the surface veneer. Normally a diluted coat of Prime IT Multi-surface Primer (3:1 with clean water) is recommended. For dense veneers of very low absorbency apply Prime IT Multi-surface Primer neat in a thin uniform coating. Allow primer coats to fully dry. Level IT one is not recommended for use in areas where hydrostatic pressure may be problematic\n?\nPLEASE SEE THE ABOVE TAB FOR TECHNICAL DATA SHEET