Ultra Floor Level IT Flex - Fibre Reinforced - 48 No. x Bags & Bottles

Product Code: 31090

UltraFloor Level IT Flex is a high specification, high strength, rapid curing, fibre reinforced two component smoothing underlayment. Specially designed for fast turnaround projects and for floors subject to slight vibration or thermal movement, UltraFloor Level IT Flex is suitable for use as an underlayment for most floor coverings including sheet vinyl, LVT, linoleum and rubber and breathable textiles.\n\n\nFibre reinforced\nUnique bag and bottle formulation\n30 minute walk on time\nBonded floor coverings after 3 hours, depending on substrate type\nIdeal for electrical underfloor heating\nMinimises cracking\nCoverage: approx 5m? at 3mm\n2-10mm thickness\nWorking time 10 minutes Internal floors\nSize: 20kg bag and bottle\n\n?\nINFORMATION\nUltra Floor Level IT Flex is a high specification, high strength, rapid curing, fibre reinforced two component smoothing underlayment system. It consists of a powdered component incorporating a blend of high specification cements, micro fibres, graded fillers and additives and a pre-gauged high polymer content liquid.\nThe two components are mixed to provide a rapid setting and curing, free flowing smoothing underlayment for smoothing a variety of internal floors, prior to the application of decorative floor coverings. It enables them to be loose laid in as little as 90 minutes (unbonded textiles), fully bonded in just 3 hours (on to solid subfloors) and 4 hours (on subfloors subject to vibration).\nThis curing profile makes it an ideal choice for use in areas where it is necessary to carry out installations in a short timeframe whilst the high polymer liquid and fibre reinforced powder make it ideal over floors subject to slight lateral movement or vibration such as screwed and fixed plywood, mezzanine decks, raised access panels (must be securely fixed) and floors with surface electrical radiant heating systems.\nIts protein free formulation means it is ideal for use in biologically sensitive areas. It can be used on a variety of subfloors and is suitable for use where warm water underfloor heating is incorporated in screeds and subfloors.\nLevel IT Flex can be applied between thicknesses of 2-10mm (on mezzanine, Plywood and raised access panels - must be securely fixed).\nIts initial set is approximately 10 minutes with a walk on time of 30 minutes. It is necessary to maintain a wet edge between mixes so working practices should be adjusted accordingly to ensure this can be achieved within the products open time. Applications up to 5mm thick on solid subfloors can normally receive floor coverings after approximately 3 hours (based on good ambient conditions).\nPLEASE SEE THE ABOVE TAB FOR TECHNICAL DATA SHEET