Mapei Ultraplan 23Kg - Full Pallet Deal - 40 bags

Product Code: 30146

Ultra-fast drying self-levelling compound\nCLASSIFICATION ACCORDING TO EN 13813Ultraplan smoothing compound as described in this data sheet is classified as CT-C30-F7-A2fl-s1 according to European Norm EN 13813.\nWHERE TO USEUltraplan is used in interiors for levelling and smoothing differences in thicknesses from 1 to 10 mm on new or existing substrates, preparing them to receive all kinds of flooring where a high resistance to loads and traffic is required. Ultraplan is especially suitable for areas subject to wheeled chairs.\nUltraplan is for interior use only.\nSome application examples• Levelling concrete slabs and cementitious screeds or Topcem, Mapecem, Mapecem Pronto or Topcem Pronto based screeds.• Levelling anhydrite substrates.• Levelling over underfloor heating systems.• Levelling existing concrete substrates, terrazzo, ceramic and natural stone.\nTECHNICAL CHARACTERISTICSUltraplan is a pinkish-grey powder consisting of special cements with rapid setting and hydration, with selected graded silica sand, resins and special additives prepared according to a formula developed in the MAPEI Research laboratories.Mixed with water, Ultraplan becomes a fluid and easily workable mortar, perfectly self-levelling, with high bonding strength to the substrate and ultra-fast drying.Ultraplan can be applied with an automatic pressure pump for distances over 100 m.Ultraplan can be spread in thicknesses up to 10 mm per coat without shrinkage, cracking or crazing, and develops very high compressive and flexural strength as well as resistance to indentation and abrasion. For thicknesses greater than 10 mm (max. 20 mm), it is recommended to add about 30% of graded sand 0/4 mm or gravel 0/8 mm.Installation of flooring can begin approx. 12 hours after the application of Ultraplan, regardless of thickness.\nRECOMMENDATIONS• Do not add more water to a mix which has already begun to set.• Do not add lime, cement or gypsum to the mix.• Do not use Ultraplan for exterior levelling works.• Do not use Ultraplan on substrates subject to continuous rising damp.• Do not apply an additional coat of Ultraplan when the previous one is completely dry; in this case first apply Primer G diluted with 1:3 of water by volume.• Do not use Ultraplan on metal surfaces.• Do not use Ultraplan when the temperature is below +5?C.• Do not apply Ultraplan in thicknesses less than 3 mm if wood is to be overlaid.\nSEE TECHNICAL DATA SHEET FOR MORE INFORMATION