Product Code: 29865
A special product from the LITHOFIN-Range for fully vitrifiedceramic and porcelain tiles (KF). Lithofin KF Protective Impregnator is a water based nearly odourless impregnator consisting of a combination of high quality water and oil resistant components.\nTechnical Data:Density: approx. 1,0 g/cm?Appearance: liquid, yellowish, clearOdour: non specificpH-Value: 3 to 6Flash Point: >65?CSolubility in Water: --\nProperties:This special impregnator effectively protects the surface against staining by inhibiting the penetration of water, oil, grease and dirt. Lithofin KF Protective Impregnator does not affect the appearance of the surface.\nField of Use:For protecting all newly laid absorbent polished and unglazed porcelain tiles in order to facilitate maintenance. Suitable for indoor and outdoor use.\nDirections For Use:The surface to be treated must be completely clean and dry. Shake Lithofin KF Protective Impregnator well before use. Apply undiluted with a clean cloth or a lambs wool roller and ensure even distribution by wiping (rolling) over the surface several times.\nFor best results, treat the surface in sections of approx 15m? at a time. After 10 to 20 minutes, completely remove any surface residues with a squeegee or with a dry cloth.\nAttention! the liquid product must sink into the stone. Immediately wipe off puddles and drips. Do not allow the product to dry on the surface. Carefully remove all residues and check against back light.\nPlease Note: Impregnators are not suitable for all porcelain tiles. Always try the product in an incon-spicuous area prior to use. Protect glass, varnished surfaces, plastics, etc. against splashes.\nCoverage: Up to 50m? per litre, depending on the absorbency of the surface.\nStorage: Keep closed, cool and dry. Shelf life of at least 12 months. Open containers should be used quickly.\nEnvironmental Protection: Solvent free, water based.Disposal: Diluted product may be added to waste water.\nContainers are made of environmentally friendly polyethylene (PE). Clean containers can be recycled through collection systems.\nSafety:Contents: polymers; water; auxiliary agents.\nGeneral Information: keep out of the reach of children. Treated surfaces present no health hazard once dry.\nFirst Aid Procedures: Remove contaminated soaked clothing immediately. In case of inhalation, ensure of fresh air.In case of contact with skin wash off immediately with soap and water. In case of contact with eyes rinse thoroughly with plenty of water and seek medical advice. In case of ingestion, do not induce vomitting. If swallowed by mistake drink plenty of water and seek medical treatment.\nEmergency Procedures: In case of spill or other release, take up with absorbent material (e.g. sand, sawdust, general-purpose binder). Ensure adequate ventilation. Product does not burn, fire-extinguishing activities according to surrounding. In case of fire formation of dangerous gases possible.\nAdditional Information is listed on the Material Safety Data Sheet. ADR2003: not a dangerous good\nPackaging:1 litre bottle with child-proof cap (10 per box)5 litre canister (2 per box)\nThis information should be considered to be informal and non-binding. The products must be used according to local conditions and materials. Where no previous experience is available, or in cases of doubt, test the product in an inconspicuous area. (GB11.04gps/12.02)
Visit the Pure Adhesion Ltd website for more information on Lithofin KF Protective Impregnator Porcelain Sealer - 1 Litre