Dry Treat INTENSIFIA Deep Enhancement & Protection - 946ml - FREE P&P

Product Code: 31116

Dry Treat INTENSIFIA is the ultimate combination of enhancer and sealer. Natural stone, masonry and other hard porous materials will have deep, long lasting color enrichment and premium water and oil-based stain protection.\nTypical Applications\nDry Treat INTENSIFIA is suitable for a wide variety of applications, including floors, walls, cladding, facades, countertops, patios, driveways, paths, garages, kitchens and entertaining areas.\nThis colour enhancer works on ?a wide variety of porous surfaces, including all types of natural stone, clay and terracotta tiles and pavers, brick, concrete, polished concrete, terrazzo, encaustic tile, terracotta and saltillo.\nDry Treat INTENSIFIAis suitable for indoor and outdoor applications and for residential and commercial buildings\n\nDeep color enhancement.\nSuper oil and water repellency for superior stain protection. ISO 10545-14 Class 5 (best possible resistance to stains), greater than 98% reduction in 24-hour water up-take (Rilem method).\nLonger lasting, even outdoors under UV light. *5 year Performance Warranty when INTENSIFIA™ is applied by an Accredited Applicator.\nEasy to apply. Additional coats can be applied at any time in the future to a cleaned surface.\nRetains surface hardness and wet slip resistance of porous flooring materials.\nWill not flake, yellow, crack, blister or break down in high alkalis and reduces concrete dusting.\nTreated surfaces dry quickly making a waterless environment for bio-films, hides scratches, efflorescence and imperfections.\nBreathable: water vapor permeates freely, avoiding moisture build-up inside the material; and is backed by a 5-year\n\n?\nHow To Use\n\nALWAYS TEST PRODUCT ON A SMALL AREA FIRST and allow a 24-hour cure time to check results. \nSurface must be clean, dry and free of residues. \nGenerously apply INTENSIFIA™ using low-pressure hand sprayer, clean brush or lamb’s wool applicator. Avoid contact with surrounding areas. \nAllow for a minimum of 30 minutes for product to penetrate the surface then thoroughly polish off any excess product residue with clean, dry, white cloths, towels or similar. \nLeave the product to cure for at least 60 minutes, then repeat steps 3 and 4. Total application rate is approximately one quart per 20-250 sq. ft (2-25 sqm) depending on surface absorption. A third coat may be required for premium stain protection on very porous surfaces. \nAvoid contact with moisture for a minimum of 8 hours after application. Full curing takes 4 weeks. \nUse an organic solvent for e.g. methylated spirits to clean equipment. \n\nNotes: INTENSIFIA™ will not prevent etching from acidic liquids, or physical surface wear. The level of enhancement will vary dependent on the type of material being treated. It is advised to test on a sample piece before applying the product to your surface. Eventually, wear and tear and cleaning will affect the enhancement and sealing performance. Reapplication of the product will be needed. Once enhanced, the treated surface cannot be restored back to the original look.\nPLEASE SEE THE ATTACHED PDF FORFULL PRODUCT SPECIFICATION\n*Please Note: We are unable to ship this item outside of mainland Great Britain (Northern Ireland, Channel Islands, Republic of Ireland etc.) in accordance with regulations on the transport of dangerous goods.